Elements of the finished parquet are laid on flat surfaces, dry and clean. Examples of different types of floor construction are given here.
1. Laying on floor coverings.
Old floor coverings are often found during remodeling activities, which are suitable as a base for laying the parquet.
(1) Element of the finished parquet, checkerboard pattern, (2) Intermediate layer, (3) Old floor covering, (4) Floating screed, (5) Insulating layer, (6) Raw ceiling
2. Laying on wooden floors.
These old wooden floors are well suited for subfloors for the finished parquet.
(1) Element of the finished parquet, ship floor structure, (2) Insulating layer, (3) Old wooden floor, (4) Beam ceiling.
3. Układanie na jastrychach
In the case of unfinished beam ceilings, it is possible to lay on a floating screed.
(1) Element of the finished parquet, (2) Intermediate layer, (3) Floating screed, (4) Insulating layer, (5) Raw ceiling.
4. Układanie na suchych podłożach.
The finished parquet can also be installed on dry floors with an insulating layer lying above them.
(1) Element of the finished parquet, checkerboard pattern, (2) Insulating layer, (3) Ribbed papa, (4) Dry bedding, (5) Raw ceiling.
5. Układanie na legarach podłogowych.
(1) Self-supporting elements of the finished parquet, braided pattern, (2) Insulating layer, (3) Floor joist, (4) Strips of insulating boards, (5) Raw ceiling.
6. Układanie nad ogrzewaniem podłogowym.
Laying the finished parquet elements on underfloor heating is not difficult, if it is carried out in compliance with the applicable installation instructions.
(1) Element of the finished parquet, ship bottom pattern, (2) a. for full-surface gluing = glue, b. for floating laying = intermediate layer, (3) hot water underfloor heating, (4) Edge insulating strips, (5) Heating screed, (6) Izolacja przeciwwilgociowa, (7) Insulating layer, (8) Raw ceiling.